Anti-Slip & Steep Driveways
Anti-Slip Resurfacing for Steep Driveways
If your driveway is slippery when it rains, resurfacing will fix it. Our coating is one of the most slip-resistant finishes available for outdoor concrete, rated P5, the highest slip rating for exterior surfaces. It stays grippy in the wet, which is exactly the problem most Sydney driveways develop after years of wear.
Steep and sloped driveways
Steep and sloped driveways are among the jobs we do most often, and they are exactly where a proper slip-rated finish matters most. Sydney has no shortage of them; the Northern Beaches, the Sutherland Shire and the North Shore are full of blocks that fall away sharply from the street.
On a steep block, replacing the slab is usually the worst option available: expensive, disruptive, and often impractical for access. Resurfacing gets you a safer, better-looking surface without any of that.
See the difference
A steep driveway, before and after
A steep driveway resurfaced with a non-slip textured finish.
Sydney
Before
After
Worth knowing
Where Anti-Slip Resurfacing Matters Most
Why painted concrete makes it worse
- Paint on a steep driveway is a genuinely bad idea.
- It lasts six to twelve months, and painted concrete gets more slippery when wet, not less.
- Our finish is a bonded, textured overlay that is the slip resistance, and it is part of the surface rather than a film sitting on top of it.
Where else it matters
- Pool surrounds, ramps, shaded side paths that never quite dry out, and steps.
- Anywhere that is wet, sloped or in shade is worth doing properly.
No change to levels
The finish is only a few millimetres thick, so there is no risk of new trip hazards and no effect on drainage. All heights and clearances stay exactly as they are.
Start to finish
Our Anti-Slip Resurfacing Process
Every job begins with a pressure wash, followed by masking of walls, garage doors, garden beds and pool fencing. We fill visible cracks, then spray the slip-rated finish on in the colour you’ve chosen and seal it. Grinding only comes into it if a surface needs old paint or a previous coating stripped first, it isn’t part of our standard process. Because the coating is only a few millimetres thick, there’s no new trip hazard and no change to drainage, even on a steep slope. Most driveways are finished in two to three days depending on size and weather, and we’ll give you a firm timeframe after seeing the job in person.
The same finish is used for our standard concrete resurfacing and over pebblecrete. Browse the colours, see our projects, or view all of our services. To get a price, get a free estimate.
All you need to do before we start is clear the areas. We handle the masking, cleaning and surface prep from there.
Keep looking
Related services
Concrete Resurfacing
Tired, stained or patchy concrete, back as a clean textured surface.
Fleck Finish Concrete
A fine speckle through the surface instead of a single uniform colour.
Any Questions
FAQs
Why is painting a steep driveway not a good option?
Paint typically lasts six to twelve months and tends to make concrete more slippery when wet, not less, the opposite of what a steep driveway needs.
Can this finish be used on ramps and steps, not just driveways?
Yes; pool surrounds, ramps, shaded side paths and steps all benefit from the same slip-rated finish.
Is a steep driveway harder to resurface than a flat one?
No extra process is needed. The same non slip, P5-rated finish and prep process is used either way.